Pearson Edexcel International Advanced Subsidiary Level in Physics (WPH11) Paper 01 Mechanics and Materials 2022 Marking Scheme
Pearson Edexcel International Advanced
Subsidiary Level in Physics (WPH11)
Paper 01 Mecha
...
Pearson Edexcel International Advanced Subsidiary Level in Physics (WPH11) Paper 01 Mechanics and Materials 2022 Marking Scheme
Pearson Edexcel International Advanced
Subsidiary Level in Physics (WPH11)
Paper 01 Mechanics and Materials
1. Mark scheme format
1.1 You will not see ‘wtte’ (words to that effect). Alternative correct wording should
be credited in every answer unless the MS has specified specific words
that must be present. Such words will be indicated by underlining e.g.
‘resonance’
1.2 Bold lower case will be used for emphasis e.g. ‘and’ when two pieces of
information are needed for 1 mark.
1.3 Round brackets ( ) indicate words that are not essential e.g. “(hence) distance is
increased”.
1.4 Square brackets [ ] indicate advice to examiners or examples e.g. [Do not accept
gravity] [ecf].
2. Unit error penalties
2.1 A separate mark is not usually given for a unit but a missing or incorrect unit will
normally mean that the final calculation mark will not be awarded.
2.2 This does not apply in ‘show that’ questions or in any other question where the
units to be used have been given, for example in a spreadsheet.
2.3 The mark will not be awarded for the same missing or incorrect unit only once
within one clip in epen.
2.4 Occasionally, it may be decided not to insist on a unit e.g the candidate may be
calculating the gradient of a graph, resulting in a unit that is not one
that should be known and is complex.
2.5 The mark scheme will indicate if no unit error is to be applied by means of [no ue].
3. Significant figures
3.1 Use of too many significant figures in the theory questions will not be prevent a
mark being awarded if the answer given rounds to the answer in the
MS.
3.2 Too few significant figures will mean that the final mark cannot be awarded in
‘show that’ questions where one more significant figure than the value
in the question is needed for the candidate to demonstrate the validity
of the given answer.
3.3 The use of one significant figure might be inappropriate in the context of the
question e.g. reading a value off a graph. If this is the case, there will be
a clear indication in the MS.
3.4 The use of g = 10 m s-2 or 10 N kg-1 instead of 9.81 m s-2 or 9.81 N kg-1 will mean
that one mark will not be awarded. (but not more than once per clip).
Accept 9.8 m s-2 or 9.8 N kg-1
3.5 In questions assessing practical skills, a specific number of significant figures will
be required e.g. determining a constant from the gradient of a graph
or in uncertainty calculations. The MS will clearly identify the number
of significant figures required.
[Show More]