What does TE in TE-601 stand for? - ANSWER temperature element
what does B.T.U stand for? - ANSWER British Thermal Unit
what is the boiling point of water? - ANSWER 212*F
What is 3.1416? - ANSWER Pi
what is t
...
What does TE in TE-601 stand for? - ANSWER temperature element
what does B.T.U stand for? - ANSWER British Thermal Unit
what is the boiling point of water? - ANSWER 212*F
What is 3.1416? - ANSWER Pi
what is the circumference of a 15" pipe? (to the nearest tenth0 - ANSWER 47"
4" in the hundredths of a foot is? - ANSWER .33
what is the take off for a 4" x 3" LR reducing 90* ell? - ANSWER 6"
on isometric drawings what does RFWN mean? - ANSWER raised face weld neck
what does the Pi in Pi-209 stand for? - ANSWER pressure indicator
101.25' converted into inches is what? - ANSWER 101'-3"
if testing the shell side of an exchanger with the flat cap removed and all the tubes on the bottom row had a steady flow of water pouring out of them, this would indicate: - ANSWER floating head gasket leaking
3/4" is equal to? - ANSWER 6/8
the lap joint flange is usually used when_______? - ANSWER flange hold alignment is a problem
what is the number of a square feet in the surface of a steel plate 180 inches high and 48 inches wide? - ANSWER 60 square feet
what device is installed between a control valve and the air supply header? - ANSWER regulator
what is the most common degree of bevel on a pipe to be butt welded? - ANSWER 37 1/2
the three states of matter are: - ANSWER solids, liquids,and gases
what is the circumference of a circle that has a 20.50 inch diameter? - ANSWER 64.37
extension lines should: - ANSWER always touch the object being drawn
what is 23% of 1598? - ANSWER 367.54
what is the circumference of a circle with a diameter of 5" - ANSWER 15.70"
what is the area of a triangle that is 30.5 feet long and 15 feet wide? (A=WxL) - ANSWER 457.5 square feet
a globe valve is used to: - ANSWER prevent flow in more than one direction
what would be the take off for a 45 standard 3" pipe ells? - ANSWER 4"
when using orifice flanges in a vapor service, the taps should be facing: - ANSWER up
what dies T.O.E stand for? - ANSWER thread one end
what does BLETSE stand for? - ANSWER bevel large end/thread small end
tools that require hearing protection when used are: - ANSWER chipping gun, side grinder, air impact
items to look for on a bench grinder before use are: - ANSWER cracked wheel, tool rest within "1/8" of wheel, tongue guard attatched
if you wanted to reduce in a line but keep the same center line, you would use an eccentric reducer - ANSWER false
the 2 most commonly used types of tubing connections are compression and flared. - ANSWER true
a pressure indicator is indicated by a Pi symbol on a flow chart - ANSWER true
[Show More]