CCNA 200-301 ALL ANSWERS 100% CORRECT SPRING FALL 2023/24 EDITION GUARANTEED GRADE A+

Document Content and Description Below

What is the primary purpose of a VLAN? To create a broadcast domain; enable segmentation or isolation of broadcast traffic Unassigned Cisco switch ports remain in which VLAN? VLAN 1Do VLANs prevent... broadcast storms? No, they minimize the size and effect of the broadcast storm on neighbor switches and hosts What are four advantages to using VLANs? 1. Enable access to network services based on logical requirements 2. Network security is optimized with VLANs that enable managing and filtering sensitive traffic from other network traffic 3. Bandwidth efficiency is accomplished through segmenting traffic into smaller broadcast domains 4. Easier add/move/delete administration of endpoints on a network and scalability for larger enterprise deployments What is the Layer 2 Broadcast Destination Address? FFFF.FFFF.FFFF What is the Layer 3 Broadcast Destination Address? 255.255.255.255 What is VLAN 1 used for and can it be deleted? Management Traffic; it cannot be deleted What is the normal VLAN range? VLAN 2 - 1001 What is the extended VLAN range? VLAN 1006 - 4094 What VLANs are auto-created and cannot be deleted? VLAN 1, 1002 - 1005 What VLANs cannot be pruned from a trunk? VLAN 1006 - 4094 How many VLANs can be assigned to a switch access port? Only one VLAN unless you are connecting an IP phone What commands would you use to setup a switch access port with an IP phone? interface <interface#/#> switchport mode access switchport access vlan # switchport voice vlan # Where is the switch VLAN configuration stored? vlan.dat file What commands would you use to globally create and name a VLAN? vlan # name <name_of_vlan> What is the default switch port mode? Access port What will switch access ports do with am Ethernet frame it receives with an 802.1q tag? It will discard the packet without learning the source MAC address What command would you use to configure a range of switch ports? interface range gigabitethernet#/# - # What command lists all VLANs configured on a switch? show vlan or show vlan brief What command is used to display the switch ports assigned to a single VLAN? show vlan id <vlan> When are data messages forwarded to the default gateway? When the destination subnet is on a different subnet than the endpoint Does the Cisco default switch configuration have an IP default gateway? No What command is used to create an IP default gateway? ip default-gateway <ip_address> What is the primary purpose of a switch? To make forwarding decisions based on destination MAC address List the network services provided by switches - Only read Ethernet frame headers and forward traffic - Create and maintain the MAC address table - Create separate collision domains per switch port - Create separate broadcast domains per VLAN What method was used for detecting Ethernet collisions on older hubs and bridges? Carrier Sense Multiple Access Collision Detection (CSMA/CD) How many separate MAC address table does a switch create? A switch creates a separate MAC address table for each configured VLAN What command lists the contents of the MAC address table for a switch? show mac address-table When does a switch begin MAC address learning? When a switch is first started and connected hosts start sending frames? Also triggered when the aging time expires for an address What is the default time that a switch removes MAC address table entries? 300 seconds How do you disable MAC address table aging? Configure the MAC aging timer to zero What are the steps when a host sends data to a server on the same VLA [Show More]

Last updated: 2 years ago

Preview 1 out of 11 pages