About This Assignment
Each of the practical lessons that you complete this month covers a handful of topics and gives you
a guided walkthrough of implementing the proper nodes. This assignment is a little bit different
...
About This Assignment
Each of the practical lessons that you complete this month covers a handful of topics and gives you
a guided walkthrough of implementing the proper nodes. This assignment is a little bit different. It
challenges you to solve many problems. It’s bigger than the other assignments and doesn’t offer
you quite as much guidance. To offset the greater challenge, you get two full weeks to work on it.
The Mega Assignment evaluates whether you have learned enough to move on to the next
scripting course.
The suggested approach for tackling this assignment is to take it one part at a time. Each Blueprint
that you have to work in has been created for you and has been divided up into commented
sections. Ideally, you’ll fill in each section and test to make sure your code compiles and runs
properly. When you complete each Blueprint, you’ll be able to play-test your code in the editor and
see that it works properly.
Creating Your Assignment
Download ITP_MegaProject.zip. Create a new folder called
LastName_FirstName_ITP_MegaProject. Instead of LastName and FirstName, use your actual last
name and preferred first name. Take special note of where your new folder is. You’ll need to be
able to get back to it later. Unzip the contents of ITP_MegaProject.zip into your new folder.
Double-click on ITP_MegaProject.uproject to open it. Click the green triangle to Play in the
Editor. You should be able to run up the hill; however, when you reach the teleporter, nothing will
happen. You need to get to the end of the obstacle course, but each of the obstacles is broken and
you have to fix it before you can move on. Each Blueprint has most of the wiring already installed in
it. You need to figure out what nodes to add and hook up to the existing wires to make each
Blueprint work again.
Fixing the Teleporter
Everything you need to fix the teleporter is in the BP_Teleporter Blueprint. There are 4 white
comment blocks that are missing code and you need to fill it back in.
The first block you need to fill in requires that you find an appropriate node to validate that the
Other Teleporter has been hooked up properly.
[Show More]