Summary Nicet Level 1 water based systems test_ 2023.

Nicet Level 1 water-based systems test_ 2023. What is a purpose of a control valve The gauge on the quick opening device shall indicate _____ as compared to the gauge on the system side of the dry pipe valve? What type o ...

Nicet Level 1 water-based systems test_ 2023. What is a purpose of a control valve The gauge on the quick opening device shall indicate _____ as compared to the gauge on the system side of the dry pipe valve? What type of test shall be provided when a valve is returned to service to determine that the valve is open? What is a fire service main? Name the system that utilizes a plate through which a passes a specific amount of foam concentrate at a specific pressure. During an inspection, which of the following would be identified as a sprinkler which shall be replaced? What are the inspection requirements for hangers and seismic braces installed in concealed spaces? Gauges shall be replaced every _____ or tested every _____ by comparison with a calibrated gauge Where air pressure supervision is connected to a constantly attended location gauges shall be inspected ______? Sprinklers installed in areas that are inaccessible for safety consideration, due to process operations ____ be ____ during each scheduled shutdown? What type of valve is designed for the purpose of reducing downstream water pressure under both residual and static conditions PIV and OS&Y shall be backed a __________ from the fully open position to prevent jamming. Gauges not accurate to within _______ percentage of the full scale shall be recalibrated or replaced? When there is a _________ reduction in full flow pressure, when compared to original acceptance test, the cause of the reduction shall be identified and corrected. An informational sign shall be placed at the _______ supplying the antifreeze loop, dry system, pre action system, or auxiliary systems control valve. Information signs should indicate which of the following? Which of the following signs require a quarterly inspection to verify that it is securely attached to the sprinkler riser? Which of the following would be an acceptable material for the information sign to be made of? How often shall the system information sign be tested? Sprinklers shall be tested for sensitivity and functionality at ______ PSI What specialized equipment is needed to test waterflow alarm devices on a wet pipe system? Sprinklers subject to overspray accumulation shall be protected by using? What type of testing requires the use of a refractometer? What type of device is used to test flow rates? Identify what type of sprinkler is designed to be installed in such a way that the water stream is directed downward against the deflector? A class 1 standpipe system is a system that provides ________ hose connections to water supply used by fire departments. What type of precautions should shall take place prior to entering confined spaces such as tanks, valve pits, or trenches? All penetrations into the area of cold storage shall be inspected. If an ice obstruction is found during the inspection, what requirement shall be employed? Internal examination of sprinkler pipe shall be performed at what areas while conducting an obstruction investigation and prevention? NFPA 25 chapter 15 outlines the procedure to follow for impairment of a water based system. Besides this code requirement other action shall be followed based on the impairment? Normally closed valves shall be secured by the means of a seal or , be ________ in accordance with the applicable NFPA standard. What is the frequency for testing the hose connections for pressure reducing and relief valves? In systems where the sole water supply is through a backflow preventer and/ or pressure reducing valves, the main drain test of at least one system downstream of the device shall be conducted ________? Hose connections should be inspected, tested, and maintained in accordance with NFPA 25 Chapter ______ and Chapter____? When is the proper time for the employee's to receive training on the company fall arrest system? What is the maximum allowed scissor lift speed? If an explosive actuated tool misfires, you should? When using compressed air for cleaning, it should be rated at less than ______ PSI? What is the minimum width allowed for the ladder stairs? Hearing protection is required when the noise level reaches 90 DBA for a duration of _________? How far above the point of support is a ladder required to extend when used to access the roof? When are hard hats required on the job sites? Scaffolding and components shall be capable of supporting a weight of? When using a grounded power tool you find an available extension cord (2 wire). What should you do? Which of the following is identified as the OSHA control of energy source standard Equipment should be locked out/ tagged out when which of the following conditions exist? Which of the following is required for locks and tags used in a lockout/ tagout procedure Sprinklers are subject to overspray accumulation shall be protected using cellophane bags having a thickness of ______? A building has 3 different types of sprinklers. How many sprinkler wrenches are required to be kept on premises? During testing of a diesel engine driven fire pump system. The fire pump is runn