OCR GCE Physics A H156/01: Breadth in physics Advanced Subsidiary GCE Mark Scheme for Autumn 2021

$ 10

Test Bank For Precalculus, Global Edition, 7th Edition by Robert F. Blitzer

$ 19

POLI 330N Final Exam 3- Question with Answers(Graded A+)

$ 10

Solution Manual For Steel Design 5th Edition by William T. Segui All Chapters 1-10 A+

$ 7.5

Test Bank for Evolutionary Analysis 5th Edition by Herron Jon; Freeman Scott ISBN 9780321998378 Chapter 1-20 A+ Latest

$ 9.5

eBook Foundations of Mixed Methods Research 2nd Edition By Abbas Tashakkori, R. Burke Johnson, Charles Teddlie

$ 29

Wise Certification Test / Practice Exam & Study Guide / 2025 Update / Score 100%

$ 18

HESI Patho Questions and Answers with Verified Solutions

$ 12

BIOD 171 Module 5 Review / Score 100% / New Version / 2025 Update / Study Guide & Test Bank

$ 10.5

2023 nclex rn uworld comprehensive study guide updated may 2023 with questions nursing

$ 18

EDEXCEL AS LEVEL JUNE 2022 HISTORY QUESTION PAPER 1H

$ 1

ENGL 147N Week 4 Assignment; Logical Fallacies Presentation

$ 18

PSC 101 – Exam 1 Study Guide (Harper College, Bobby Summers) with Core Concepts and Practice Questions

$ 11

eBook An Introduction to Critical Thinking and Creativity Think More, Think Better 1st Edition By Joe Y. F. Lau

$ 30

ATI Remediation Advanced Test rationale (Latest-2021) 100% Correct Answers, Download to Score A

$ 15

Electrical Engineering > Lab Report > POWER TRANSMISSION AND DISTRIBUTION NETWORK (All)

POWER TRANSMISSION AND DISTRIBUTION NETWORK

Document Content and Description Below

POWER TRANSMISSION AND DISTRIBUTION NETWORK Submitted by: SAMIR BISTA (32379056) OMAR AL SIDAIRI (32829004)1. EXECUTIVE SUMMARY As per the given task, we are supposed to work-out an appropriat ... e cable combination and figure out which combination of cable would give load voltage within 5% to the supplied load. We had three loads in our project and we were given two types of cable (chlorine and hydrogen). As per the combination, (3C2) we now had 8 optional arrangements for the cables. After applying all the cable formation in our simulation, we found that all 8 arrangements of cable gave the load voltage within 5% of the supplied load. We assumed that because of less distance and low impedance values of the cable there is not much loss on transmission and effect on load voltage resulting in less difference. The best result was observed when all three cable were hydrogen. We also assumed power factor to be 0.8 and then 0.9. Result were better when power factor in 0.9 than 0.8, which is expected because improved power factor improves the result. Even though, HHH (all hydrogen) cable combination proved to be more efficient in both case of power factor, we do need to consider the cost of this design. As we are assuming the cost to purchase and install the cable to be proportional to the cross-sectional area of the cable, HHH cable configuration was most expensive and ClClCl was most inexpensive, and our choice of configuration considering cost and efficiency is HClCl and ClHH, which will be later discussed in the project [Show More]

Last updated: 3 years ago

Preview 1 out of 22 pages

Buy Now

Instant download

We Accept: