MEEN 225
Project 2-MEEN225
Project 2
EQUILBRIUM OF A SINGLE RIGID BODY
Project Overview
In this project we will analyze the forces produced when raising a load using three-cable rigging
system similar to Figur
...
MEEN 225
Project 2-MEEN225
Project 2
EQUILBRIUM OF A SINGLE RIGID BODY
Project Overview
In this project we will analyze the forces produced when raising a load using three-cable rigging
system similar to Figure 1. In our situation, we will study a case where the load may shift position
within the load basket, and how load position affects the tensions developed in the rigging system.
The objective of the analysis will be to determine the realized Factor of Safety (FoS) for the rigging
cables. The realized factor of safety is a measure of how close the working loads of a system are to
the failure point of the system. A realized factor of safety for a rigging cable can be calculated by:
??? =
????? ???????ℎ ?? ?????
?????? ??????? ???? ?? ?????
Project Objectives
By doing the project, students should be able to:
• Apply equations of equilibrium to solve for unknown forces for a point mass in three
dimensions
• Determine the orientation of an single rigid body suspended at a point above it center of
gravity
• Introduce coordinate system to geometric model of real system
• Represent geometrical parameters and forces present in real system in terms of coordinate
system selected
• Identify most limiting case for underspecified loading condition
• Determine a realized factor of safety for prescribed situation
Demonstration A: Place the can of soda at the center of the box and lift it by the main lifting eye.
With the model held stationary, take a picture of the model. What is the approximate orientation
of the box relative to the horizontal plane (you may estimate or measure)? Which of the rigging
cable(s) do you think carries the most load? Explain your answer.
Demonstration B: Place the can of soda at the corner of the box and lift it by the main lifting eye.
With the model held stationary, take a picture of the model. What is the approximate orientation
of the box relative to the horizontal plane (you may estimate or measure)? Which of the rigging
cable(s) do you think carries the most load? Explain your answer. Does the choice of corner make
a difference in your results?
[Show More]