MAE 1351 EXAM 2 LATEST 2022 QUESTIONS AND ANSWERS
An assembly cannot be nested inside another assembly; only parts can. -Answer- False
I bring a part into assembly in SW, and click the OK check Mark in the top righ
...
MAE 1351 EXAM 2 LATEST 2022 QUESTIONS AND ANSWERS
An assembly cannot be nested inside another assembly; only parts can. -Answer- False
I bring a part into assembly in SW, and click the OK check Mark in the top right. This will... -Answer- Align the component origin with assembly origin
I bring a cube into assembly and mats coincident it's edge to a fixed edge, how DOFS are left ? -Answer- 2
I bring a cube into assembly mate coincident one of its vertices to a fixed vertex, how many DOFs are left? -Answer- 3
For every mate I apply, I reduce the DOF of the part by... -Answer- Depends on the mate
I bring a cylinder into an assembly and mate parallel one if it's flat faces to the top plane, this loses how many DOFs -Answer- 2
I bring a cylinder into an assembly and mate tangent it's curved surface to a curved surface of a fixed cylinder, longitudinally these cylinders are parallel, how many DOFS? -Answer- 3
The equivalent of mass in a rotational system is called the -Answer- Moment of intertia
I have an assembly with moving parts and wish to check that I have part clearances throughout, for this I need -Answer- Motion study
In a SW assembly it is possible to assign an arbitrary motion to a component to visualize its overall behavior, true? -Answer- Yes, very easily
In FEA (finite element analysis) certain physical values are specified at the edge and nodal points as -Answer- Boundary conditions
Screw thread -Answer- helix or conical spiral formed on the conical spiral formed on the external surface of a shaft or the internal surface of a cylindrical hole
Axis -Answer- A longitudinal centerline of the thread
Root -Answer- The bottom of the cut on external threads
Crest -Answer- Top of the external threads
Major diameter -Answer- Largest diameter of a screw thread. The distance is measured from crest to crest through an axis on an external thread.
Minor diameter -Answer- Smallest diameter of a screw thread. The dimension is measured from root to root through the axis on an external thread.
Pitch diameter -Answer- Imaginary diameter measured from a point halfway between the major and minor diameters through the axis to a corresponding point on a corresponding point on the opposite side.
Pitch -Answer- Distance from a point on a screw thread to a corresponding point on the next thread as measured parallel to the axis.
Depth of thread -Answer- Distance between the crest and the root of a thread as measured perpendicular to the axis.
Angle of thread -Answer- The included angle between the sides of the thread
Body -Answer- That portion of a screw shaft that is left unthreaded.
Chamfer -Answer- An angular relief at the last thread engage more with a mating part; commonly applied to the first thread to help start a thread in its mating part.
Classes of threads -Answer- A designation of the amount of tolerance and allowance specified for a thread
Fit -Answer- Identifies a range of thread tightness or looseness
Thread series -Answer- Groups of common major diameter and pitch characteristics determined by the number of threads per inch
Lead -Answer- Distance of a screw thread advances axially in one full turn
American National Thread -Answer- 60 degree V-Thread (Standard) used in USA, Canada and UK
Square thread -Answer- Best thread for transmitting power. Difficult to manufacture-replaced by ACME thread(ex. screw jacks, vice screw)
Buttress thread -Answer- Designed for applications with high stress in one direction (ex. breech assemblies of large guns, airplane propeller hubs, columns for hydraulic presses)
Rolled thread (knuckle) -Answer- usually rolled from sheet metal (ex. light bulbs, light sockets, bottle tops)
Tap cuts -Answer- internal threads
[Show More]