Georgia Drivers Ed Unit 5 Questions and
Answers Graded A+
Expressways routinely have lower crash frequency rates than other roadway types ✔✔True
There are numerous advantages to expressway driving over two-lane roads,
...
Georgia Drivers Ed Unit 5 Questions and
Answers Graded A+
Expressways routinely have lower crash frequency rates than other roadway types ✔✔True
There are numerous advantages to expressway driving over two-lane roads, One of those
advantages is: ✔✔Supports higher traffic volume
Driving too slowly on expressways can be just as dangerous as driving too quickly ✔✔True
HOV lanes are generally less congested than other lanes on an expressway and are used for:
✔✔Vehicles with more than one occupant
Driving exiting the expressway should be prepared to exit by_______appropriately as the
specific exit nears ✔✔Changing lanes
Lanes of traffic on expressways that flow in opposing directions are divided by a: ✔✔Median
seasonal hazards include which of the following? ✔✔Snow, ice, and sleet
Rain
Heat
If bad pavement is encountered a driver should: ✔✔Slow speed, stay in the same lane as much as
possible and drive with special attention until reaching an area of good pavement
High traffic volume allows more vehicles on the expressway due to the design of ✔✔multiple
lane roads
The high risk driving environment routinely involves: ✔✔Intersections of varying volume and
complexity
High traffic volume
Limited time and space to identify critical incidents and roadways conditions
__________are designed to absorb the impact of a high speed crash ✔✔Guardrails
Stopping, turning, and crossing the median on expressways are prohibited. ✔✔True
Expressways are designed to assist drivers in early identification of roadway: ✔✔hazards and
conditions
Pedestrians, bicyclists and slow-moving vehicles are not allowed on expressways because
expressways have minimum speed limit requirements that these travelers cannot reach ✔✔True
HOV is a euphemism for: ✔✔High Occupancy Vehicle
Traveling on multiple-lane roadways is often faster than traveling on local roadways due to the
lack of intersections that require stopping ✔✔True
It is acceptable to stop in any lane of the expressway ✔✔False
________are areas of uneven pavement that make the vehicle unbalanced. ✔✔Dropoffs
The speed limit on Georgia expressways is up to 70 mph. ✔✔True
Heat can create including glare, reflections or brushfires. ✔✔True
Expressway entrances include: ✔✔An entrance ramp, acceleration ramp, and merge area
The driver________the expressway has the right of way in weave lanes. ✔✔Exiting
Focusing on the________to merge into will assist in making adjustments in driving if that area
becomes unavailable before reaching it. ✔✔Chosen space gap
When exiting an expressway,____________your current speed when preparing to exit
✔✔Maintain
If you see a sign stating Wrong Way or Do Not Enter when entering an expressway, you should:
✔✔Pull the vehicle to the side of the road and stop immediately. Then turn the vehicle around
and exit the area
When entering an expressway, a driver in the acceleration lane must decrease speed in order to
not obstruct expressway traffic. ✔✔False
At the end of the exit lane of an expressway, there may be a stop or yield sign ✔✔True
Traffic in the right lane at an entrance ramp and merge lane should move to the_________lane in
order to let entering traffic have space to merge. ✔✔Center left
Slow moving vehicles that travel at a speed less than 25 mph are not permitted on an
expressway. ✔✔True
Less congested lanes on an expressway mean there is more room and correct_______will be
followed ✔✔Space cushions
Exiting the expressway occurs at an appropriate exit area. Exiting an expressway includes: ✔✔A
merge area
A deceleration ramp
An exit ramp
Large vehicles have difficulty changing lanes due to: ✔✔A large blind spot
It is appropriate to drive side-by-side with other vehicles in the other lanes. ✔✔False
Merging vehicles should always give existing expressway traffic the right of way. ✔✔False
Entering and exiting vehicles on an expressway share a ramp on_______which can cause
conflicts. ✔✔Weave lanes
Driving too slowly is just as dangerous as driving too quickly. ✔✔True
Before entering an expressway, look for____________signs stating wrong Way or Do not enter
✔✔Read and white
__________are needed to avoid two vehicles transitioning to the same spot in the same lane.
✔✔Scanning techniques
When transitioning into a merge lane with expressway traffic, you should use your_________to
communicate your intention to other drivers. ✔✔Turn signal
Some problems associated with lane management include: ✔✔Poor visibility
Congestion on the ramp
Driver choosing the wrong lane
_____________are diamond shape and predominantly yellow and black ✔✔Warning signs
Traffic signals on expressways are typically located near the shoulder of the expressway or on
overhead posts. ✔✔True
__________Indicate no passing or crossing ✔✔Solid yellow lines
Signs that use blue, white and red colors and have the interstate number located on the middle of
the sign are: ✔✔Interstate signs
Guide signs on expressways are predominantly green and white. ✔✔True
__________can cause drivers to feel as if the have less control of the vehicle. ✔✔Cross winds
A lane identified by a diamond painted in the lane of travel is called a: ✔✔High occupancy
vehicle lane
Which of the following signs are green and white and give roadway guidance information?
✔✔Guide signs
The three most common expressway interchange types are cloverleaf, diamond and trumpet
interchanges ✔✔True
_____________allow drivers to pass other vehicles ✔✔Broken white lines
__________may include traffic control devices on the intersecting secondary roadways
permitting turns onto the secondary roadway. ✔✔Diamond interchange
A_____________helps protect opposite lanes of traffic from collisions. ✔✔Median barrier
If the electronic turn signal does not work on a vehicle, a driver should utilize the appropriate
hand signal to indicate the intention to turn ✔✔True
A solid yellow line is always on the drivers left side ✔✔True
A green arrow over a lane indicates the lane is prohibited ✔✔False
Around construction areas, drivers should allow for____________following distance at the front
and rear of the vehicle ✔✔Increased
Solid white lines mark the edges of pavement and should not be crossed ✔✔True
Expressway lane markings are of a different design and meaning as on other roadways. ✔✔False
Parking or stopping on expressways is not permitted unless it is on the shoulder of the
expressway. ✔✔True
______________are designed with a secondary multiple lane roadway ✔✔Diamond interchange
An example of a regulatory sign is: ✔✔No Right Turn sign
One Way sign
Speed limit sign
Examples of cloverleaf interchanges are usually found when interstate feeder roads terminate at
an interstate highway ✔✔False
A cloverleaf interchange typically includes_______to permit traffic leaving one roadway and
concurrently exiting from another roadway ✔✔Weave lanes
Slower moving vehicles should travel in the_________lane. ✔✔Right
Raised highway dividers serve the same purpose as____________ ✔✔Solid yellow lines
[Show More]