CIP 2 Questions and Answers 100%
Pass
You are the NACE Coating Inspector on a tank lining project and are asked to perform a high
voltage holiday test after the coating applicators have completed their final repairs.
...
CIP 2 Questions and Answers 100%
Pass
You are the NACE Coating Inspector on a tank lining project and are asked to perform a high
voltage holiday test after the coating applicators have completed their final repairs. After meeting
all the confined space entry permit you enter the tank and notice a very strong odor of solvent.
Your first course of action should to:
Exit the tank and immediately and report the problem to the nearest safety supervisor
You are working as an inspector in a galvanizing plant for the first time. What are some of the
hazards you need to be aware of:
A. Risk of chemical exposure
B. Risk of skin
C. Risk of acid or caustic splashes
D. a), b), and c)
Answer: D
You are working as the only in-house NACE Level 2 Inspector in a shop setting when an
independent 3rd party NACE Level 3 Inspector, representing the owner, presents you with a
copy of a Non Conformance Report (NCR) he has written for a NACE2/SSPC SP 10 centrifugal
blast which you had previously approved.
Your FIRST preferred course of action is to:
Consult your supervisor
An Inspection and Test Plan is required when:
It is always required
The Inspectors' goal at the Pre-Job Conference is to:
Obtain a clear understanding of the Specification
Coating Surveys are legally required:
On commercial marine vessels and offshore platforms
Individuals conducting Coating Surveys should:
Always be trained and experienced Coating Industry
The cost of qualified Coating Inspection is normally offset by:
Lower Coating Life Cycle Costs
You are a NACE Level 2 Coating Inspector who has just arrived on a job in progress where there
is no Inspection and Test Plan (ITP). The first morning you arrive the job is behind schedule and
you are asked to take DIY Film Thickness readings.
Your FIRST preferred course of action is to:
Use a generally accepted industry standard and to take readings
When conducting inspections the Inspector should follow which standards:
The specified standards
You are the NACE Level 2 Coating Inspector where SSPC PA 2 has been specified with an
additional requirement that no individual gauge reading shall be below a certain value.
As this is not part of the standard you should
[Show More]
