CIP Level 1 Questions and Answers
Graded A+
You are the NACE inspector on a tank lining project where a 50% solids epoxy tank lining is
being applied. After application of the 19 coat, you notice small blisters in som
...
CIP Level 1 Questions and Answers
Graded A+
You are the NACE inspector on a tank lining project where a 50% solids epoxy tank lining is
being applied. After application of the 19 coat, you notice small blisters in some areas of the
applied lining. Your FIRST preferred course of action is to:
A. Break the blisters to see what's inside
B. Document the problem and advise the contractor and owner's representative
C. Document the problem and advise the contractor
D. Extract any liquid that may be inside the blister and sent it to the lab for further analysis.
✔✔Document the problem and advise the contractor and owner's representative
The dew point is the temperature at which
A. Water freezes
B. humidity decreases
C. Condensation occurs
D. the air is saturated ✔✔condensation occurs
If a contractor is using a poorly maintained compressor to supply air for abrasive blast cleaning
and conventional airspray, the coating inspector should perform a
A. dry film thickness (DEI) measurement
B. wet film thickness (WFT) measurement
C. blotter test for the presence of oil and water
D. vial test ✔✔blotter test for the presence of oil and water
Upon arrival of coating materials, the inspector should
A. review coating contractors' plans for storage of coating materials and confirm they meet
national, local, and owners' fire and environmental regulations
B. observe and document the amount material and batch numbers
C. observe aryl document that the applicator WFT at regular intervals during application
D. observe and document time frame and environmental conditions between each coat
✔✔observe and document the amount material and batch numbers
Relative humidity is
A. a measure of the amount of moisture in the air compared to saturation level
B. a measure of the amount of moisture in the air compared to the air temperature
C. the lowest temperature at which moisture forms on a steel surface
D. the highest temperature at which moisture forms on a steel surface ✔✔a measure of the
amount of moisture in the air compared to saturation level
Galvanic corrosion occurs on which of the following substrates:
A. concrete
B. fiberglass reinforced plastic
C. metal
D. wood ✔✔metal
When applying Thermal spray coatings, the specification is most likely to reference:
A. SSPC PA 2
B. NACE SP 0178
C. NACE SP 0188
D. SSPC-CS 23.00/AWS C2.23/NACE No.12 ✔✔SSPC-CS 23.00/AWS C2.23/NACE No.12
What is the minimum recommended distance away from an edge that an inspector should take
measurement with a dial-type magnetic pull-off Dry Film Thickness (DFT) gauge?
[Show More]
