Engineering > QUESTIONS & ANSWERS > MSSC- M3 Machine Tooling Questions and Answers Graded A+ (All)

MSSC- M3 Machine Tooling Questions and Answers Graded A+

Document Content and Description Below

MSSC- M3 Machine Tooling Questions and Answers Graded A+ During the drilling of a hole, the drill is raised to ✔✔clear the chips from the hole To drill a hole in a part, the _ of the circle is ... indicated with layout lines ✔✔center point Which of the following is not a part of the twist drill? ✔✔chip breaker Which of the following is an example of an unsafe practice while operating a drill press? ✔✔Stooping down to look closely at the part and drill, as the drill enters the metal to make sure it's positioned properly A drill press ✔✔uses a rotating tool to cut into material A drill press is used to ✔✔create holes Engineers sometimes use a _ to measure angles on a drawing ✔✔protractor The size of a drill is usually stamped on its ✔✔shank Which of the following is an example of an unsafe practice while setting up the drill press? ✔✔Examining a large part and deciding to hold it in place by hand since it's so large, it will not fit in the vise Layout work is the operation of ✔✔transferring date from a technical drawing to the part Which of the following is not commonly used oil for creating a cutting fluid? ✔✔Motor A _ punch is used to create a very small indentation ✔✔prick A worn drilling tool ✔✔should not be used _ are used to lift the work piece off the bottom of the vise ✔✔parallels A drill press will undersize the holes if the ✔✔drill bit has a worn margin A(n) _ is used to tighten the drill in the chuck of the drill press ✔✔chuck key A tool should be wiped clean ✔✔after each use [Show More]

Last updated: 2 years ago

Preview 1 out of 3 pages

Buy Now

Instant download

We Accept: