1. Strain Gauge
1. Why must the strain gauge be glued and not just taped to the sample?
Using glue ensures a good transfer of strain from the material to the strain gauge which is due
to the strain gauge being physica
...
1. Strain Gauge
1. Why must the strain gauge be glued and not just taped to the sample?
Using glue ensures a good transfer of strain from the material to the strain gauge which is due
to the strain gauge being physically and uniformly adhered to the surface of the material.
2. What happens to resistance in the strain gage and voltage drop from a connected
Wheatstone bridge if you were to pull the strain gauge along the long axis?
Pulling the strain gauge in the long axis would elongate/thin the wires in the strain gauge
causing an increase in resistance and an increase in voltage drop (V = I*R).
3. What happens to resistance and voltage drop if you were to pull the strain gauge along
the short axis?
The resistance and voltage drop will still increase but at a smaller rate than the intended axis
such as the long axis.
4. Other than applying a strain to the gauge, what is the primary external/environmental
factor that will influence the readings of a strain gauge? What effect does it have on
resistance and voltage drop?
As temperature increases, resistance increases and voltage drop increases.
2. Wheatstone Bridge
1. How many strain gauges are used in the following Wheatstone Bridge set ups? (Fill in
the numbers)
a. Quarter Bridge: ___1__
b. Half Bridge: _____2___
c. Full Bridge: ____4_____
2. Describe the benefit of two active strain gauges in a half bridge configuration.
The benefit of two active strain gauges in a half bridge configuration is to compensate for
temperature error and provide a more accurate strain gauge reading.
3. Knowing that the two strain gauges are on parallel branches (R1 and R4 in this
configuration), how does one active gauge and one inactive gauge allow for temperature
compensation?
[Show More]