Engineering > Lab Report > MicroComputer Lab 5 Report University of Guelph ENGG 3640 (All)

MicroComputer Lab 5 Report University of Guelph ENGG 3640

Document Content and Description Below

ENGG3640 Lab 5: ADC & PDB 1.0. Introduction 1.1. Lab Description Lab 5 was designed to allow a greater understanding of ADC conversion, its uses and implementation on the TWR-K60D100M microcont ... roller. Using the circuit constructed from Lab 4, a volt meter was created to measure the mean voltage of an input square wave, and display it on a 3-digit, 7-segment display. Furthermore; the TWR-K60D100M output the measured signal after the ADC calculation, and the delay between signals was measured 1.2. System Requirements (Tools & Equipment) ● Keil uVision ● Freescale TWR-K60D100M ● Connection cable between PC and board ● Breadboard ● 2n2222 transistors ● 330 ohm resistors ● 7 segment display ● Oscilloscope ● Function generator 2.0. Background 2.1. Overview of programming tools & Devices Used The equipment used during the lab was the Freescale Low-Power MCU, TWR-K60D100M. The kit uses a USB connection to sync with the Keil uVision software that is available through the computers in the lab. 3.0. Implementation 3.1. Top-Down Functional Implementation 3.1.1. Software Implementation [Show More]

Last updated: 3 years ago

Preview 1 out of 9 pages

Buy Now

Instant download

We Accept: