NETA 2 Exam Questions with accurate answers, Verified.

NETA 2 Exam Questions with accurate answers, Verified. Under what considerations can tag out without lock out be permitted? - ✔✔-***&If an energy isolating device is not capable of being locked For PV systems, a(n) ...

NETA 2 Exam Questions with accurate answers, Verified. Under what considerations can tag out without lock out be permitted? - ✔✔-***&If an energy isolating device is not capable of being locked For PV systems, a(n) _____ is a device that changes direct-current input to an alternating-current output. - ✔✔-Inverter Identify the contact pictured above. (NC and NO separated by a node) - ✔✔-Form C When applying personal protective grounds, which end is attached first? - ✔✔-***&The equipment end An induction motor has 40kVA input power, a power factor of 82 percent, and an efficiency of 92 percent. What is the horsepower? - ✔✔-***&30.2 HP How many connection points would you expect to find on a kelvin bridge? - ✔✔-4 You arrive at a job to perform acceptance testing on a new-indoor 15KV switch lineup. While the equipment has been installed multiple covers are off there are power conductors hanging with taped ends. What should you do? - ✔✔-***&Visually confirm that the source of power have already been deenergized and lock out What is the turns ratio of a 3-phase 500kVA, 13,200-480 volt rated delta-delta transformer that is 80% loaded? - ✔✔-***&22.000 ***27.500 ASTM D 924 is a required acceptance test for liquid-filled transformers with natural ester insulating fluid per NETA standards. - ✔✔-***&True NETA-ATS requires test decals be affixed on the exterior of equipment or equipment enclosure of protective devices after performing electrical tests. Which color test decal would you affix to a piece of equipment with a minor deficiency that does not affect its fault detection or operation? - ✔✔-Yellow What is meant by a "dead tank breaker?" - ✔✔-The external tank is grounded. If you have your ground conductor running through your zero-sequence CT with your current carrying conductors, what will happen? - ✔✔-Ground fault protection won't function Which of the following would best describe a 52 device: - ✔✔-AC circuit breaker A series circuit has two resistors. The resistors dissipate 10 W and 15 W. What is the total power dissipation of the circuit? - ✔✔-25 W Which of the following would be the best choice for use in both the conductive and mechanical areas of circuit breakers and switches? - ✔✔-Mobil 28 What is the power factor temperature correction value for new mineral oil? - ✔✔-***&20C/40C OSHA requires the testing of a volt meter after a voltage test on voltage above ______. - ✔✔-600V A tagout device must be strong enough to remain attached under a minimum of ____ lbs of force. - ✔✔- 50 A piece of wire that is 0.001 inches in diameter and 12 inches long is one mil-foot. - ✔✔-True At least 2 entrances of sufficient area must be provided giving access to the electrical equipment working space. - ✔✔-***&True What is the Restricted Approach Boundary for a 69kV system? - ✔✔-***&3 ft 10 in. Which portion of the transmission system experiences faults occur most frequently? - ✔✔-Overhead lines To reverse the direction of rotation of a three-phase motor, reverse: - ✔✔-any two leads When can an unqualified person enter the Limited Approach Space? - ✔✔-***&They are never allowed within the Limited Approach space Cells are connected in series to increase: - ✔✔-***Voltage rating The three-phase connection in which one end of each of the windings are connected together is called the _____ connection. - ✔✔-***delta What is the recommended minimum insulation-resistance value for motor windings made before 1970? - ✔✔-***100 Megohms per kV + 1 A digital multimeter, when set to read voltage, has an input impedance of - ✔✔-***a fixed, high impedance regardless of range Class 00 rubber insulating gloves are proof tested at 2,500 VAC, what color label would you expect to find on these gloves? - ✔✔-***White Write three thousand fortyeight tenthousandths in decimal form. - ✔✔-***0.3048 What is the primary purpose of the National Electrical Code? - ✔✔-***The practical safeguarding of persons and property from electrical hazards. Each switchboard used as service equipment should be provided with a main bonding jumper. - ✔✔- ***True Harmonics increase the risk of fire and electric shock. - ✔✔-***True The ________ section of a switchboard receives power from the service section and feeds it to various downstream loads. - ✔✔-***distribution Three inductors of 60mH, 120mH and 75mH respectively, are connected together in a parallel combination with no mutual inductance between them. Calculate the total inductance of the parallel combination in millihenries. - ✔✔-***26 mH What is the distance between points (3, 5) and (4, 5) on the rectangular coordinate grid? - ✔✔-***1 Which of the following sets of terminals would you expect to find on a DLRO? - ✔✔-***C1, P1, C2, P2 Determine the RMS amplitude of this sinusoidal waveform, as displayed by an oscilloscope with a vertical sensitivity of 0.2 volts per division: - ✔✔-***0.32 The dataplate on a condenser bushing shows values for C2. What do these represent? - ✔✔-***The power factor and capacitance that should be measured between the tap and the ground flange What does the I represent on a circuit breaker which has a solid state LSIG trip device? - ✔✔- ***Instantaneous The main advantage of aluminum bus bar is: - ✔✔-***low cost Shown below is a current transformer with the number of turns between taps. What is the calculated voltage for taps X1 to X3 when 200 V is applied to the full secondary winding (X1 to X5)? - ✔✔-***60V Using the diagram shown, what is the total circuit resistance? - ✔✔-***10 ohms A given transformer has insulating fluid with a specific gravity greater than 1, from where would you draw a sample? - ✔✔-top For a DAR test of a transformer, the reading at 1 minute is divided by a reading at: - ✔✔-***60 seconds Sample valves should be flushed with at least _____ of waste liquid before collecting a transformer liquid sample. - ✔✔-***one quart Underground service conductors between the terminals of service equipment and service lateral or underground service conductors are termed as _____ . - ✔✔-***Service Point Conductors In the picture below, would rated ear muffs be adequate hearing protection? - ✔✔-***no In a zone-interlocked low voltage circuit breaker protection scheme, the trip unit responsible for clearing the fault is inoperative. Which statement is true? - ✔✔-***The downstream circuit breaker will trip In a purely inductive circuit, the phase angle between the voltage waveform and current waveform will have a _____ phase shift. - ✔✔-***90 degrees The smallest particle of a substance where it still retains it's properties is a/an______. - ✔✔- ***molecule The breaking capacity of a circuit breaker is usually expressed in: - ✔✔-Amperes Only qualified workers are allowed within the Limited Approach Boundary. - ✔✔-***True ***False Which of the following is not a factor in the operating speed of a relay? - ✔✔-***rate of flux build up A downstream 30A fuse will always blow before an upstream 100A fuse. - ✔✔-***false Which of the following ratios is equal to the ratio 8:22? - ✔✔-***4:11 The grounded conductor is one of the two conductors through which normal circuit current flows. - ✔✔- ***False In an inductive circuit, the voltage waveform lags behind the current waveform. - ✔✔-***False What respirator is used when there is insufficient oxygen in a confined space or area, and where the concentration of airborne substances in immediately dangerous to life and health? - ✔✔-***Air purifying What color test decal you affix to a protective device that is not suitable for service? - ✔✔-***Red What is the insulation level of a cable marked MV-90/175mils? - ✔✔-100% What can change the voltage output of an energized transformer? - ✔✔-***Load-tap-changer Shielded cables and twisted pairs are used more frequently in communication circuits to reduce mutual coupling. - ✔✔-***True An electrical hazard/risk analysis only looks at the hazards involved with performing energized work. - ✔✔-***False In a three-phase connection, the current that flows in a winding is the _____ current. - ✔✔-***Phase What is the NETA-ATS recommended test voltage for a 15 minute withstand test on a 3-phase, 34.5kV line sectionalizer with a rated impulse withstand voltage of 150kV? - ✔✔-***78kVAC When measuring voltage with a multirange voltmeter, which one of the following ranges should be applied first? - ✔✔-***0-1000 V Electromotive force is measured in _____. - ✔✔-***volts Power Factor equals? - ✔✔-***Watts / VA What is the minimum oxygen level before entering a transformer? - ✔✔-***11.5% To make a resistance measurement, start w