Jumpmaster General Knowledge ExamCombined, Questions with accurate answers, 100% Accurate, graded A+

Document Content and Description Below

Jumpmaster General Knowledge ExamCombined, Questions with accurate answers, 100% Accurate, graded A+ T-11 Weight - ✔✔-Approximately 38 pounds T-11 Diameter - ✔✔-Nominal 28.6 feet T-11 De ... sign - ✔✔-Modified Cruciform Planform T-11 Maximum Drop Speed - ✔✔-150 knots T-11 Minimum Drop Speed - ✔✔-50 knots T-11 Average Deployment Time - ✔✔-6.5 seconds T-11 Rate of Decent - ✔✔-Approximately 18.5 feet per second with a suspended weight of 400 lbs Ten Major Components of the T-11 Main Parachute - ✔✔--*Universal Static Line Modified -Deployment Bag -Drogue Parachute -Bridle Assembly -Deployment Sleeve -Canopy Assembly -Slider -*Riser Assembly -*Harness Assembly -*Pack Tray *items seen or touched while performing JMPI on a properly rigged jumper Nine Points of Adjustment on the Harness Assembly - ✔✔--Chest Strap - Main Lift Web (2) -Leg Strap (2) -Sizing Channel (2) -Horizontal Backstrap (2) Army Parachute Log Record Form - ✔✔-DA Form 3912 T-11 Reserve Weight - ✔✔-14.8 pounds T-11 Reserve Diameter - ✔✔-Approximately 29 feet T-11 Reserve Design - ✔✔-Aero Conical T-11 Reserve Rate of Descent - ✔✔-Approximately 26 feet per second with a suspended weight of 382 lbs Eight Major Components of the T-11 Reserve Parachute - ✔✔--*Ripcord Assembly -*Reserve Closing Loop -Protection Cap -Ejector Spring Assembly -Reserve Extractor -Reserve Canopy -*Reserve Risers -*Reserve Pack Tray *items seen or touched while performing JMPI on a properly rigged jumper Items with a Tensile Strength of 15 pounds - ✔✔--Main Curved Pin Securing Tie (Orange Type 8/4 Cotton Thread) Items with a Tensile Strength of 50 pounds - ✔✔--Connector Snap Retaining Tie (One Turn of Lacing and Tying Tape) Items with a Tensile Strength of 200 pounds - ✔✔--Main Curved Pin Attaching Loop (3/8 inch wide Type I Preshrunk Nylon Webbing, White or Green) Items with a Rated Capacity of 500 pounds - ✔✔--Chest Strap Friction Adapter (Cadium Plated Forged Steel Alloy) -Triangle Link (Cadium Plated Forged Steel Alloy) Items with a Tensile Strength of 500 pounds - ✔✔--Static Line Slack Retainer Loop (9/16 inch wide Type I Nylon Webbing) -Outer Static Line Stow Bar (9/16 inch wide Type I Nylon Webbing) -Inner Static Line Stow Bar (9/16 inch wide Type I Nylon Webbing) Items with a Tensile Strength of 600 pounds - ✔✔--Curved Pin Lanyard (Dacron Cord) Items with a Tensile Strength of 700 pounds - ✔✔--Main Closing Loop (White Spectra Cord) -Reserve Closing Loop (White Spectra Cord) Items with a Rated Capacity of 920 pounds - ✔✔--Cable Loop (Flexible Stainless Steel Aircraft Cable) Items with a Rated Capacity of 1,750 pounds - ✔✔--Universal Static Line Snap Hook (Type 4140 Steel) Items with a Rated Capacity of 2,500 pounds - ✔✔--Male Fitting Canopy Release Assembly (Cadium Plated Forged Steel Alloy) -Female Fitting Canopy Release Assembly (Cadium Plated Forged Steel Alloy) -Main Lift Web Adjuster (Cadium Plated Forged Steel Alloy) -Equipment Ring (Cadium Plated Forged Steel Alloy) -Ejector Snap (Cadium Plated Forged Steel Alloy) -Quick Fit V-Ring (Cadium Plated Forged Steel Alloy) -Backstrap Adjusters (Cadium Plated Forged Steel Alloy) Items with a Tensile Strength of 2,500 pounds - ✔✔--Diagonal Backstrap Retainer (Type VIII Nylon Webbing) -Diagonal Backstrap Keeper (Type XVII Nylon Webbing) -Horizontal Backstrap Retainer (Type VIII Nylon Webbing) -Horizontal Backstrap Keeper (Type XVII Nylon Webbing) Items with a Tensile Strength of 3,600 pounds - ✔✔--Reserve Riser (Type VIII Nylon Webbing) Items with a Tensile Strength of 4,000 pounds - ✔✔--Universal Static Line Modified (3/4 inch, tube edge, Type 6.6 Nylon Webbing, Yellow) -Waistband (Type VIII Nylon Webbing) -Reserve Carrying Handle (Type VIII Nylon Webbing) -Waistband Retainer (Type VIII Nylon Webbing) Items with a Rated Capacity of 4,200 pounds - ✔✔--Connector Snap (Cadium Plated Forged Steel Alloy) Items with a Rated Capacity of 5,000 pounds - ✔✔--D Ring (Cadium Plated Forged Steel Alloy) Items with a Tensile Strength of 5,500 pounds - ✔✔--Risers (Type VII Nylon Webbing) -Harness Assembly (Primarily Type VII Nylon Webbing) -Chest Strap (Type VII Nylon Webbing) -Saddle (Type VII Nylon Webbing) -Leg Straps (Type VII Nylon Webbing) -Diagonal Backstrap (Two Plies of Type VII Nylon Webbing) -Horizontal Backstrap (Type VII Nylon Webbing) Items with a Tensile Strength of 6,000 pounds - ✔✔--Main Lift Web (Type VII Nylon Webbing and Type VIII Nylon Webbing) -Waistband Adjuster Panel (Type VII Nylon Webbing) What does the JM Team do prior to conducting SAT? - ✔✔-Inspect helmets, ID Tags, ID Cards, and perform a technical inspection of the jumper's combat equipment when applicable. Three Phases of SAT? - ✔✔--Actions in the Aircraft Brief (SERJT/E) and Mock Door Training -Pre-Jump Training -Parachute Landing Falls (PLF's) What does SERJT/E stand for? - ✔✔--Static Line Control -Exiting Procedures -Red Light Procedures -Jump Refusals -Towed Jumper Procedures -Emergency Procedures Ground Evacuation Alarm - ✔✔-1 Continuous Ring of the Alarm Bell Crash Landing/Ditching Alarm - ✔✔-6 Short Rings of the Alarm Bell Bailout Alarm - ✔✔-3 Short Rings of the Alarm Bell followed by One Long Continuous Ring or Verbal Warning How many times can the JM Team exit jumpers from the mock doors? - ✔✔-As many times as they feel is necessary. How many times must jumpers exit from the mock doors? - ✔✔-At least twice, with the last exit being conducted as planned for the airborne operation. When should SAT be conducted? - ✔✔-No earlier than 48 hours before take off. What are the two Pre-Jump formations? - ✔✔--Extended Rectangular Formation -Horseshoe Formation What height should the PLF platform be at a minimum? - ✔✔-24 inches ACH Sizes - ✔✔--Small -Medium -Large -Extra Large Three Major Components of the ACH - ✔✔--Helmet Shell -Suspension Pad System -Modified Chinstrap Assembly Two Authorized Suspension Pad Sizes - ✔✔--Size 6 -Size 8 How thick are size 6 suspension pads? - ✔✔-3/4 inch How thick are size 8 suspension pads? - ✔✔-1 inch Modular Airborne Weapons Case Sizes - ✔✔--Small -Large Small MAWC Width and Length - ✔✔-Width: 14 inches (top) tapered to 7 inches (bottom) Length: 43.5 inches adjustable to 34.5 inches Small MAWC Maximum Internal Weight Capacity - ✔✔-65 pounds Weapons Accommodated by Small MAWC - ✔✔--M4/M16 Series Rifle -M249 SAW Large MAWC Width and Length - ✔✔-Width: 16 inches (top) tapered to 11 inches (bottom) Length: 52.5 inches adjustable to 41 inches Large MAWC Maximum Internal Weight Capacity - ✔✔-85 pounds Weapons Accommodated by Large MAWC - ✔✔--M240 MG -60mm Mortar -Sniper Rifles Can an M240 MG be placed inside of a Small MAWC? - ✔✔-Yes, if the barrel is removed. Length of Hook Pile Tape Lowering Line - ✔✔-15 feet Where are the first set of hook and pile tabs on the Modified Hook Pile Tape Lowering Line? - ✔✔-46 to 48 inches from the ejector snap Where is the blue strata mark on the Modified Hook Pile Tape Lowering Line? - ✔✔-16 to 18 inches from the ejector snap Items with a Tensile Strength of 3,600 pounds - ✔✔--Harness Single Point Release (Type VIII Nylon Webbing) Items with a Tensile Strength of 4,000 pounds - ✔✔--Hook Pile Tape Lowering Line (1 inch wide Tubular Nylon Webbing) T-10 Cargo Parachute Minimum Weight - ✔✔-90 pounds T-10 Cargo Parachute Maximum Weight - ✔✔-500 pounds T-10 Cargo Parachute Recommended Training Weight - ✔✔-350 pounds Two Types of Containers - ✔✔--A-7A Cargo Sling -A-21 Cargo Bag A-7A Cargo Sling Components - ✔✔--Strap -Friction Adapter on End of Strap -D Ring A-7A Strap Length - ✔✔-188 inches A-7A Maximum Dimensions - ✔✔--30 inches wide -48 inches long -66 inches high (to include cargo parachute) A-7A 2 Strap Load Weight Capacities - ✔✔-90-300 pounds A-7A 3 Strap Load Weight Capacities - ✔✔-300-400 pounds A-7A 4 Strap Load Weight Capacities - ✔✔-400-500 pounds A-21 Cargo Bag Components - ✔✔--Canvas Cover -Sling Assembly with Scuff Pad -Quick Release Assembly -2 O Ring Straps Sling Assembly with Scuff Pad Main Strap Length - ✔✔-188 inches Sling Assembly with Scuff Pad Side Strap Lengths - ✔✔-144 inches Scuff Pad Dimensions - ✔✔-30 inches x 48 inches A-21 Maximum Dimensions - ✔✔--30 inches wide -48 inches long -66 inches high (to include cargo parachute) What can the height of the A-21 Cargo Bag be extended to? - ✔✔-69 inches What can A-21 Cargo Bag be extended to accommodate? - ✔✔--2 Stinger Missiles -90mm recoiless rifle Three Safety Features of the A-21 Cargo Bag - ✔✔--Safety fork and lanyard -Turn to unlock -Strike/press to release A-21 Cargo Bag Minimum Weight - ✔✔-90 p [Show More]

Last updated: 2 years ago

Preview 1 out of 30 pages